Blade-Tech Kydex Outside-The-Waistband Holster for TASER Pulse and Pulse +

Commentators Stating that it grips the Taser too tightly or will not fit a 2.25" Duty Belt should seriously be considered whether they be competent enough to carry such a device.On the front face of the Taser is a single Phillips Head screw. That screw is the tensioner. Either loosen it slightly for an easier draw or tighten it for a tighter draw. If you prefer an easy draw I would suggest the application of a very tiny amount of the weakest Lok-Tite to the screw threads in order to ensure that the loose screw does not ever back out and become lost.As for the belt adjustment, it is easily adjusted as follows. Remove the Taser from the holster. If it is too tight and the Taser will not easily slide out of the holster, simply loosen the screw mentioned at the beginning of this text. Refer to the rear of the holster. With the holster pointed down, locate the eight rectangular slots. The bar that the eight slots are cut terminates into a (U) shaped frame with squared-off edges. The (U) shaped frame acts as a spacer preventing the two locking clips from being depressed on either side of the bar. At the bottom of the (U) shaped frame, you will find two small fingernail ridges. Use your fingernail to press down on the bottom of the (U) frame. This will cause the (U) frame to pivot out on a hinge. (If too tight, use a small flat screwdriver.) Once the (U) frame is fully pivoted out both locking clips (each with knurled edges) can be squeezed inward thus allowing the entire locking frame to pivot outward, open. Once the locking frame is opened you will find two spacers that are pressed into (one each) of the rectangular slots in the spacer bar. These spacers are easily popped out and can be repositioned into any of the slots in order to fit your particular belt. One or both spacers can be removed in order for the holster to fit on larger belts. In order for the holster to fit on a 2.25" wide duty belt, both spacers will have to be completely removed.I have found this holster to be of high quality and well worth the price. I expect many years of quality service from my Taser Pulse Holster.D Hessler

Cool

Fits and feels good. I like the adjustable tension

While the product is almost top notch, the screws to adjust the cant of the holster are set into slotted 'nuts'. With the screws inset all the way in, it's close to impossible to remove the screws because the 'nuts' are slotted for a straight blade screwdriver - the screws protrude into the slot area making extraction of the screws almost impossible.

5 stars on everything else for sure, but 4 for comfort, only because the gun itself is already overly thick, therefore adding a holster makes it even more thick and awkward to conceal. If you don't care about concealing it, no problem.I also have to say this makes a perfect safety guard, if younger children are around. It seems to have 2 notches, 1 for easy draw, 2 for very difficult to draw the gun from it. I would say most kids under the age of 7-8 would not be able to remove it from the holster, making it impossible to discharge. Fair warning though, I'm an average man and it took a lot of force to remove it. Carrying it around snapped all the way into the holster wouldn't allow enough time in an emergency situation. I'm not sure if this was intentional or a design flaw.

Great fit for my Taser Pulse. I like the little adjustable plastic pieces that allow you to ensure a snug fit on your belt. I swap between my duty belt and my regular belt all the time and it’s very easy. Highly recommend!

Very poor product. Battery holder very cheap pick gun up to use no power bang around then power . Next time go to use no power. Never depend on this taser gun to work for self defense!!

Took the waist/belt clip off and stuck someVelcro on it for my edc bag. Not in issue this far.